Xycd60 Manual -

is a versatile DC battery charge and discharge controller module designed for systems ranging from

Tips and Tricks

P-2 (Discharging Mode)

: Connect a battery to the input and a load to the output. It cuts off the load when the lower voltage limit ( dn ) is reached to prevent over-discharge. Parameter Setting : xycd60 manual

1. Power supply → Connect DC source (6–60V) to IN+ / IN- terminals.
2. Load → Connect device to COM and NO (normally open) or NC (normally closed) depending on fail-safe preference.
3. Current sensing → Route load current through the built-in shunt (on-board thick traces). No external shunt needed for ≤10A.

• Ensures correct, safe setup and avoids voiding warranty.
• Helps extend device life through proper maintenance.
• Saves time by providing official troubleshooting steps and exact error-code meanings.