Samsung Aj068txj3kg Eu Installation Manual -

Samsung AJ068TXJ3KG/EU

The is a multi-split outdoor unit (Free Joint Multi - FJM) designed for residential and small commercial use. It is a versatile system that can connect to up to three indoor units , providing independent climate control for different rooms. Key Technical Specifications Cooling Capacity: Nominal 6.8 kW (24,000 BTU). Heating Capacity: Nominal 8.0 kW.

Apply electronic leak detector or soap bubbles to all flares, brazed joints, and service ports. No bubbles allowed. samsung aj068txj3kg eu installation manual

Remove the unit from its carton. Verify contents: Samsung AJ068TXJ3KG/EU The is a multi-split outdoor unit

Disclaimer: This guide is for informational use by qualified HVAC professionals only. Improper installation may void warranty, cause fire, or lead to refrigerant emission penalties under EU F-Gas Regulation 517/2014. Always follow the official Samsung installation manual shipped with your AJ068TXJ3KG/EU unit. and current rating

Verify the model number and check for any transit damage before beginning work. Phase 2: Mechanical Installation Fixing the Unit:

The manual, which had been downloaded from the Samsung website, provided detailed instructions on how to install the unit, including the necessary precautions and safety measures. John carefully read through the manual, noting the specific requirements for the EU market, such as compliance with the EU's Ecodesign Directive and the need to register the unit with the relevant authorities.

Before starting, refer to the official Samsung AJ068TXJ3KG/EU Support Page to download the latest PDF manuals.

Isolation and protection: Dedicated circuit with proper overcurrent protection (breaker/fuse) and residual current device (RCD) where required; lock-off and isolate before work.
Earthing/grounding: A reliable earth connection consistent with local code; verify continuity and bonding.
Supply rating and cable sizing: Follow manual’s specified voltage, phase (single/three), and current rating; size conductors for continuous load and voltage drop.
Control wiring: Low-voltage controls must be segregated or screened as recommended; route away from power cables to minimize interference.
Commissioning checks: Verify correct voltage, phasing (if three-phase), rotation, and that all protective devices are in place and labelled.