Mi A0101 Test Point Exclusive Link
Emergency Download (EDL)
To access the mode on a Xiaomi Mi Pad (A0101) , you must locate and short specific "test points" on the device's motherboard. This hardware-level method is typically used to unbrick the device, bypass locks, or flash firmware when standard software methods fail. Locating the A0101 Test Points
If you see "QUSB_BULK" or "900E," the short failed. You are not in exclusive mode. Retry the pressure and angle of the tweezers. mi a0101 test point exclusive
- Disassemble the device to expose the Mi A0101 PCB.
- Locate the test point (e.g., TP1904 or similar marking) and a ground pad nearby.
- Short the test point to ground using tweezers or a jumper wire.
- While shorted, connect the phone to a PC via USB.
- Release the short after 2–3 seconds.
- Check PC’s Device Manager for Qualcomm HS‑USB QDLoader 9008.
- Magnification (microscope recommended)
- Fine tweezers or jumper wire
- EDL-capable USB cable (or normal USB + test point method)
short (connect)
Use a pair of tweezers or a conductive wire to the two identified test points together. Emergency Download (EDL) To access the mode on
: For newer Xiaomi models (Snapdragon-based), shorting test points triggers Qualcomm HS-USB QDLoader 9008 mode. However, the Mi Pad 1 uses an NVIDIA Tegra K1 processor. Tegra Recovery (APX Mode) Disassemble the device to expose the Mi A0101 PCB
test point
Normally, you enter EDL using a fastboot command ( fastboot oem edl ). However, if the bootloader is locked or the system partition is corrupt, that command fails. Shorting the physically bypasses the boot ROM and forces the processor to wait for a flash command over USB. The "A0101 exclusive" point is the only physical bridge that achieves this on specific Xiaomi boards.
