Hw 130 Motor Control Shield For Arduino Datasheet

Go to product viewer dialog for this item.

The (often labeled as an L293D Motor Driver Shield) is a versatile, low-cost expansion board for the Arduino Uno and Mega. It is essentially a clone of the original Adafruit Motor Shield V1 , designed to drive inductive loads such as relays, solenoids, DC motors, and stepper motors. Key Technical Specifications

2.1 Power Connectors & Jumpers

According to various technical datasheets for this hardware revision: Adafruit Motor Shield hw 130 motor control shield for arduino datasheet

Output Current:

0.6A per channel (1.2A peak) with thermal shutdown protection. Pinout and Hardware Setup Go to product viewer dialog for this item

  • VIN / VM: External motor supply (connected to shield motor power terminal)
  • GND: Common ground (Arduino GND and motor GND tied)
  • 5V: Arduino 5V (do not power Arduino from motor supply unless board supports regulator/jumper)

10. Mechanical Drawing & Mounting