Introduction
The "repack" version often circulated in the tech community typically includes:
: Performs a deep wipe and re-initialization of the flash memory, which can take anywhere from 30 minutes to several hours depending on the drive's condition. Key Specifications Supported Controllers : Specifically optimized for the FirstChip FC1178 Version Details
Identify the Chip
: Use a tool like ChipGenius to confirm your drive uses a FirstChip controller (e.g., VID=FFFF, PID=5678).
- Recognition of USB drives via shorting test points (using a “pre-format” mode)
- Low-level scanning for bad blocks and disabling defective memory areas
- Adjusting total capacity (e.g., restoring fake 64GB drives to true 8GB)
- Rewriting firmware to handle stuck “ready” states
- Setting custom USB strings (manufacturer, product, serial number)
Caution
: Using MpTools will erase all data on the target USB drive. It is recommended to verify your chip using a tool like ChipGenius before proceeding to ensure the controller matches the software.
- Windows 7 SP1 (x64 recommended)
- 1GB RAM
- USB 2.0 port (USB 3.0 preferred for FC1179)
- Administrator rights
Firstchip Fc1178 Fc1179 Mptools V1052 Repack -
Introduction
The "repack" version often circulated in the tech community typically includes:
: Performs a deep wipe and re-initialization of the flash memory, which can take anywhere from 30 minutes to several hours depending on the drive's condition. Key Specifications Supported Controllers : Specifically optimized for the FirstChip FC1178 Version Details firstchip fc1178 fc1179 mptools v1052 repack
Identify the Chip
: Use a tool like ChipGenius to confirm your drive uses a FirstChip controller (e.g., VID=FFFF, PID=5678). Introduction The "repack" version often circulated in the
- Recognition of USB drives via shorting test points (using a “pre-format” mode)
- Low-level scanning for bad blocks and disabling defective memory areas
- Adjusting total capacity (e.g., restoring fake 64GB drives to true 8GB)
- Rewriting firmware to handle stuck “ready” states
- Setting custom USB strings (manufacturer, product, serial number)
Caution
: Using MpTools will erase all data on the target USB drive. It is recommended to verify your chip using a tool like ChipGenius before proceeding to ensure the controller matches the software. Recognition of USB drives via shorting test points
- Windows 7 SP1 (x64 recommended)
- 1GB RAM
- USB 2.0 port (USB 3.0 preferred for FC1179)
- Administrator rights