The standard , which covered the tensile testing of artificial leather and similar sheet materials, was officially withdrawn in 2007 . To achieve "better" results or compliance with modern industry requirements, you should transition to its active international successor, DIN EN ISO 1421 . Recommended Modern Feature: Transition to ISO 1421
| Step | Action | |------|--------| | 1 | Cut tape to 25 mm wide x 150 mm long. | | 2 | Clean test panel (glass or stainless steel) with isopropyl alcohol. | | 3 | Apply tape to panel with an overlap of exactly 25 mm x 25 mm (ensuring 125 mm hangs free). | | 4 | Roll a 2 kg rubber-faced roller over the taped area twice (once forward, once back) at 10 mm/s. | | 5 | Wait defined dwell time (typically 20 min, 24 hours, or 72 hours depending on spec). | | 6 | Mount panel vertically in a shear test stand. | | 7 | Attach a 1 kg weight to the free end of the tape. | | 8 | Start timer. Record time when weight falls. | | 9 | Report result in minutes, and describe failure type (adhesive/cohesive). | din 53354 pdf better
Understanding DIN 53354: The Standard for Artificial Leather Testing DIN 53354 The standard , which covered the
DIN 53354 is part of a series of test methods for materials like synthetic leather, coated textiles, and rubber-coated fabrics. Unlike standards focused on woven or non-woven textiles alone, DIN 53354 specifically addresses the behavior of materials with a continuous coating. The "Better" Approach: Do not base new testing
: This is the primary replacement for testing the tensile strength and elongation of rubber- or plastic-coated fabrics. It includes two main methods: Strip Test : Clamps the specimen over its entire width.