Digi Sm-500 Scale User Manual //top\\ | Top 100 Fast |

Introduction

Basic Weighing (Direct Mode)

1. Turn off the scale.
2. Press and hold MODE, then press ON/OFF (keep holding MODE until “CAL” appears).
3. Place the 500g weight on the center of the platform.
4. Wait for “PASS” or “200.0” (or similar) to appear. Calibration is complete.
5. Remove the weight and turn the scale off/on.

The display will show the unit abbreviation at the right side.

Comprehensive Operation & Programming Guide

Q: Can I weigh something heavier than 500g if I use a container?

A: No. The total weight on the pan (container + contents) must never exceed 500g. Overloading will trigger “EEEEE” and may damage the sensor. digi sm-500 scale user manual