7004t-lm-v3 Password — Reset

To reset the password for the 7004T-LM-V3 (typically a board used in various H.264 DVRs and security systems manufactured by Xiongmai Technology

• Watch the SYS LED. It will flash rapidly, then turn solid, then begin flashing again.

• Connect via serial console (use correct baud rate—commonly 9600 or 115200).
• Interrupt bootloader/boot sequence when prompted.
• Use bootloader commands to reset configuration or enable single-user mode to change passwords.
• Reboot into normal mode and set a new password.

Step 4

: Enter this code into the DVR's password field. If successful, the system will allow you to create a new admin password immediately. Method 3: CMOS Battery Removal 7004t-lm-v3 password reset

More

Navigate to (or the monitor icon) > Reset Device Password (or "Forgot your device password"). Scan the QR code displayed on the DVR monitor. To reset the password for the 7004T-LM-V3 (typically

The app will send a reset code to the email address you linked during the initial setup. Final Tips for Success Watch the SYS LED

Common Issues and Troubleshooting

1. Power off the 7004t-lm-v3 (unplug the power adapter).
2. Press and hold the Reset button using your paperclip.
3. Continue holding the button while you power the device back on.
4. Keep holding for 20–30 seconds.

   Part 4: Accessing After Reset – IP Address & Login